Bait Pumps | Aqua World Thru Hull Bait Pumps

E-Z Release Mounting Bracket & Pump With the Aqua-World E-Z Release Mounting Bracket there is no priming bulb needed and no noise! Simply mount the E-Z Release Bracket underwater on the transom, flush with the bottom of the boat.

The submersible Rule pump, in a cup assembly, slides into the bracket; snapping into a locking position.The pump is easily removed by pushing the Flex-Tab forward and pulling the pump out of the bracket.

Water is pumped through the filter slots and supplied directly to the bait tank or bag above. Pump includes a 6 foot wire leads and accepts 3/4" ID hose.(EZ-1100 accepts 1 1/8" ID hose or adapts to standard garden hose thread with included snap-on fitting.)

aquaworld bait pump

Model Number	Gallons Per Hour	Tank Capacity Max. Gal.	Amp. Draw
EZ-360	360	20	2.5
EZ-500	500	30	2.5
EZ-700	700	45	4
EZ-1100	1100	60	5

Thru-Hull Bait & Wash Down Pump
Compact Rule pumps with 3/4" male pipe threads. Mount directly into thru-hull shut-off valve housing (no nipple needed).

Completely subversive
Low Amperage Draw
Non-corrosive
Silent Running
Ignition Protected
Water Cooled 12 volt Motor
Long Lasting Continuous Operation
No Burn Out If Run Dry
Airlock Resistant
12 Month Warranty

These reliable centrifugal pumps are non-self priming and must be mounted below the boat's water level. The deeper mounted, the more efficient they will be. Mounting the pump horizontally by use of a 90° male/female elbow will put the pump lower in the bilge, and with the outlet facing upward, will actually help prevent airlocks.

thru hull pump

Model Number	Gallons Per Hour	Tank Capacity (gal)	Amp. Draw
TH-360	360	up to 22	2.5
TH-500	500	22-36	2.5
TH-700	700	35-45	4
TH-1100	1100	40-50	5